DreamChaser AJ
New Member
Hi all,
I thought I'd open this up for general advice, but I have a bunch of figures that have had the clear plastic shunt snapped off of the base and stuck inside the figure. Is there any way to remove that piece from the figure without destroying the plastic, so I can reuse the figure? If I can't reuse the base, that's fine, I'll just take the base from another figure.
I thought I'd open this up for general advice, but I have a bunch of figures that have had the clear plastic shunt snapped off of the base and stuck inside the figure. Is there any way to remove that piece from the figure without destroying the plastic, so I can reuse the figure? If I can't reuse the base, that's fine, I'll just take the base from another figure.